Configuring Icmp Test Parameters - Huawei S9300 Configuration Manual

S9300&S9300E Terabit Routing Switch
Configuration Guide - Network Management
Applicable Environment
An ICMP test has a similar function with the ping command, but its output is more detailed.
Pre-configuration Tasks
Before configuring the ICMP test, configure reachable routes between the NQA client and the
tested device.
Data Preparation
To configure the ICMP test, you need the following data.
No.
1
2
3
4

6.5.2 Configuring ICMP Test Parameters

This part describes how to set ICMP test parameters.
Context
Do as follows on the NQA client:
Procedure
Step 1 Run:
system-view
The system view is displayed.
Step 2 Run:
nqa test-instance admin-name test-name
An NQA test instance is created and the test instance view is displayed.
Step 3 Run:
test-type icmp
The test type is set to ICMP.
Step 4 Run:
destination-address { ipv4 ip-address | ipv6 ipv6-address }
Issue 01 (2012-03-15)
Data
Administrator name and test name of the NQA test
Destination IP address
(Optional) Virtual Private Network (VPN) instance name, source interface that sends
test packets, source IP address, size of the Echo-Request packets, TTL value, ToS,
padding character, interval for sending test packets, and percentage of the failed NQA
tests
Start mode and end mode
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
6 NQA Configuration
263