Checking The Configuration; Configuring The Aggregation Statistics About Ipv4 Traffic; Establishing The Configuration Task - Huawei S9300 Configuration Manual

S9300&S9300E Terabit Routing Switch
Configuration Guide - Network Management
----End

7.4.7 Checking the Configuration

Prerequisites
The configurations of the NetStream function are complete.
Procedure
Step 1 Run the display netstream all command to view the NetStream configuration.
----End
7.5 Configuring the Aggregation Statistics About IPv4
Traffic
This section describes how to configure the statistics about IPv4 aggregation traffic passing an
interface.

7.5.1 Establishing the Configuration Task

Applicable Environment
When the NetStream function is configured in the IPv4 network, a mode of collecting statistics
about aggregation traffic must be configured to classify statistics about packets according to
certain rules.
Pre-configuration Tasks
Before configuring NetStream for aggregation traffic, complete the following tasks:
l
l
Data Preparation
To complete the configuration, you need the following data.
No.
1
2
Issue 01 (2012-03-15)
NOTE
If the reset ip netstream cache slot slot-number command is run before the inactive aging timer expires,
the statistics are not sent to the NSC.
Setting physical parameters on an interface
Setting the link-layer parameters of the interface
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
7 NetStream Configuration
Data
Name and number of the interface on which
traffic statistics need to be collected
Version number of exported packets of the
NetStream traffic statistics
511