Configuring The Lsp Ping Test Parameters For The Ldp Tunnel - Huawei S9300 Configuration Manual

S9300&S9300E Terabit Routing Switch
Configuration Guide - Network Management
No.
1
2
3
4
6.16.2 Configuring the LSP Ping Test Parameters for the LDP
Tunnel
Before performing an LDP LSP ping test, you need set parameters for the LSP ping test.
Context
Do as follows on the NQA client:
Procedure
Step 1 Run:
system-view
The system view is displayed.
Step 2 Run:
nqa test-instance admin-name test-name
An NQA test instance is created and the test instance view is displayed.
Step 3 Run:
test-type lspping
The test type is set to LSP Ping.
Step 4 Run:
lsp-type ipv4
The tunnel type is set to be the LSP tunnel.
Step 5 Run:
destination-address ipv4 ip-address { lsp-masklen masklen | lsp-loopback loopback-
address }*
The destination IP address to be tested is configured.
Step 6 (Optional) Perform the following as required to configure other parameters for the LSP Ping
test:
Issue 01 (2012-03-15)
Data
Administrator name and test name
l For the LSP tunnel: destination IP address and mask of the LSP Ping test
l For the MPLS TE tunnel: interface number of the TE tunnel
l For the MPLS CR-LSP hotstandby tunnels: interface number of the TE tunnel
(Optional): LSP EXP value, response mode of Echo packets, padding field of a
packet, packet size, number of probes for one NQA test instance, interval at which
packets are sent, source address where packets are sent, TTL, test failure conditions,
historical records and result records, aging time, and test interval.
Start mode and end mode of the test
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
6 NQA Configuration
299