Trace Subsystem - Keysight N1911A Programming Manual

P-series power meters

Hide thumbs Also See for N1911A:

Table of Contents

TRACe Subsystem

This command can only be used with P-Series and E9320 sensors. The E9320

sensor must be set to NORMal mode.

The TRACe subsystem is used to:

– Specify the type of trace to be captured.

– Enable/disable trace capture.

– Specify the trace units.

There are two pre-defined TRACE blocks:

– TRACe1: associated with Channel A

– TRACe2: associated with Channel B

The following commands are described in this chapter:

:MEASurement

:PULse[1]|...|10

:SEParation?

Parameter Form

<character_data>

<numeric_value>

<numeric_value>,

<numeric_value>

N1911A/1912A P-Series Power Meters Programming Guide

[query only]

[query only]

[query only]

[query only]

[query only]

Table of Contents