10
SENSe Subsystem
[SENSe[1]]|SENSe2:CORRection:CSET[1]|CSET2 Commands
These commands are used to select the active sensor calibration table (using
CSET1) and the active frequency dependent offset table (using CSET2).
If any of the CSET1 commands are used when a P-Series, N8480 Series
NOTE
(excluding Option CFT) or E-Series power sensor is connected, the error –241,
"Hard ware missing" occurs.
The following commands are detailed in this section:
[SENSe[1]]|SENSe2:CORRection:CSET[1]|CSET2[:SELect] <string>
[SENSe[1]]|SENSe2:CORRection:CSET[1]|CSET2:STATe <boolean>
396
N1911A/1912A P-Series Power Meters Programming Guide