Service:sensor[1]|2:Cplace - Keysight N1911A Programming Manual

15 SERVice Subsystem

SERVice:SENSor[1]|2:CPLace?

This query returns the calibration place in P-Series, E-Series sensors and N8480
Series sensors. Calibration place information is stored in the sensor's EEPROM.
Syntax
Example
SERV:SENS2:CPL?
Error Messages
– If no power sensor is connected, error –241 "Hardware missing" occurs.
– If a sensor other than a P-Series, N8480 Series or E-Series power sensor is
710
SERV :SENS
connected, error –241 "Hardware missing" occurs.
1 :CPL
2
This query returns the place of calibration of
the P-Series, E-Series sensor or N8480
Series sensor connected to Channel B.
N1911A/1912A P-Series Power Meters Programming Guide
?