Table 12-26 802.11A And Hiperlan2: Power Meter Presets - Keysight N1911A Programming Manual

802.11a and HiperLan2
The following table shows the power meter presets when <character_data> is set
to 802DOT11A and HIPERLAN2. Commands not listed are preset according to their
DEFault values (for further information refer to
Table 12-26 802.11a and HiperLan2: Power Meter Presets
Command
Frequency
[SENS[1]]|SENS2:FREQ[:CW|:FIX]
Sensor measurement mode
[SENS[1]]|SENS2:DET:FUNC
Sensor video bandwidth setup
[SENS[1]]|SENS2:BAND|BWID:VID
Gate Setup
[SENS[1]]|SENS2:SWE[1]|2|3|4
:OFF:TIME
[SENS[1]]|SENS2:SWE[1]|2|3|4
:TIME
Trigger setup
TRIG[:SEQ[1]|2]:SOUR
INIT:CONT
TRIG[:SEQ]:LEV:AUTO
TRIG[:SEQ]:LEV
TRIG[:SEQ]:SLOP
TRIG[:SEQ]:DEL
TRIG[:SEQ]:HOLD
N1911A/1912A P-Series Power Meters Programming Guide
Setting
+5200.000 MHz
NORM
E9321A/25A: DEF
E9322A/26A: DEF
E9323A/27A: HIGH
N1921/2A: HIGH
Gate 1: 0
Gates 2 - 4: 0
Gate 1: 25 µs
Gates 2 - 4: 0
INT1
ON
ON
AUTO
POS
0 s
MIN
SYSTem Subsystem
Table 12-1).
Comments
Frequency setting
Measurement mode
Sensor video bandwidth
Delay between trigger point and time
gated period.
Length of time gated period for time gated
measurements.
Trigger source set up and acquisition
mode continuous triggering
Enable automatic setting of the trigger
level
Power level
Trigger event recognized on the rising
edge of a signal
Delay between recognition of trigger event
and start of a measurement
Trigger holdoff
12
565