Table 10-2 Measurement Units; Sense[1]|2:Trace:limit:upper <Numeric_Value - Keysight N1911A Programming Manual

10 SENSe Subsystem
SENSe[1]|2:TRACe:LIMit:UPPer <numeric_value>
This command sets the upper scale limit of the trace for the specified channel.
The units used are dependent on the current setting of SENS:TRAC:UNIT as shown
in
Table 10-2 Measurement Units
SENS:TRAC:UNIT
The trace lower scale limit is maintained at a lower power than the upper scale
NOTE
limit which is adjusted to be slightly greater than the lower scale limit if
necessary. Refer to
page 456 for further information on setting the trace lower scale limit.
Syntax
:SENS
458
Table 10-2.
Units:
dBm
W
"SENSe[1]|2:TRACe:LIMit:LOWer <numeric_value>"
1 :TRAC
2
N1911A/1912A P-Series Power Meters Programming Guide
:LIM :UPP
Units:
SENS:TRAC:LIM:UPP
dBm
W
Space
numeric_value
DEF
MIN
MAX
Space
?
on
MIN
MAX