Lan Configuration - Keysight N1911A Programming Manual

1 Power Meter Remote Operation
For information on setting the GPIB address manually from the front panel, refer
to the P-Series Power Meters Installation Guide.
– To set the GPIB address from the remote interface use the:
– To query the GPIB address from the remote interface use the:

LAN Configuration

The power meter has three LAN operating modes:
– Dynamic IP (Dynamic Host Configuration Protocol or DHCP)
– Auto IP (Local PC Control or isolated (non-site) LAN)
– Static IP (Manual mode)
These three modes can be set up from the front panel. For front panel operation
refer to the P-Series Power Meter Installation Guide.
Configuring the LAN Remotely
To automatically configure the LAN settings, enable DHCP operation using the
SYSTem:COMMunicate:LAN:DHCP[:STATe] command.
In this Dynamic IP mode the IP Address, Subnet Mask, and Default Gateway
values are obtained from a DHCP server. Using this Dynamic IP mode does not
require a detailed knowledge of your network configuration.
The IP Address, Subnet Mask, Default Gateway, and Host settings can be
changed manually or remotely. To individually specify the LAN settings, use the
following commands:
– IP Address -SYSTem:COMMuniucate:LAN:ADDRess
– Subnet Mask -SYSTem:COMMunicate:LAN:SMASk
– Default Gateway -SYSTem:COMMunicate:LAN:DGATeway
– Domain Name -SYSTem:COMMunicate:LAN:DNAMe
– Hostname -SYSTem:COMMunicate:LAN:HNAMe
– Restart Network -SYSTem:COMMunicate:LAN:RESTart
30
SYSTem:COMMunicate:GPIB:ADDRess command.
SYSTem:COMMunicate:GPIB:ADDRess? query.
N1911A/1912A P-Series Power Meters Programming Guide