9
PSTatistic Subsystem
PSTatistic:CCDF:REFerence:DATa?
This command is used to retrieve the reference trace data and it is independent of
the channel attached. The reference trace data will be returned only if there is a
reference trace saved.
This command is only applicable when P-Series sensors are present and the
NOTE
following conditions are met:
– Free-run acquisition mode is selected
– NORMal or DOUBle measurement speed setting is chosen
The reference trace data returned in the format as shown below:
NOTE
– The reference trace data maximum X-axis value in dB
– 501 points of the reference trace data
Syntax
Example
PST:CCDF:REF:DAT?
Reset Condition
On reset, the trace will be cleared.
330
PST
:CCDF
:REF
:DAT
This command returns the previously saved
reference trace data.
N1911A/1912A P-Series Power Meters Programming Guide
?