Table 12-17 Bluetooth: Power Meter Presets - Keysight N1911A Programming Manual

12 SYSTem Subsystem
BLUetooth
The Bluetooth set-up provides:
– Average power in a Bluetooth DH1 data burst.
– Peak power in the same burst
– Display of RF pulse in one timeslot
The measurement is started by detecting the Bluetooth RF burst using the
internal RF level trigger. The internal trigger is set to –20 dBm. Time-gating is
used to measure the peak and average power in a single Bluetooth DHI data burst
which lasts for 366 us. The DHI burst does not occupy a full Bluetooth timeslot,
which lasts for 625 µs.
The following table shows the power meter presets when <character_data> is set
to BLUetooth. Commands not listed are preset according to their DEFault values
(for further information refer to
Table 12-17 BLUetooth: Power Meter Presets
Command
Frequency
[SENS[1]]|SENS2:FREQ[:CW|:FIX]
Sensor measurement mode
[SENS[1]]|SENS2:DET:FUNC
Sensor video bandwidth setup
[SENS[1]]|SENS2:BAND|BWID:VID
Gate Setup
[SENS[1]]|SENS2:SWE[1]|2|3|4
:OFF:TIME
[SENS[1]]|SENS2:SWE[1]|2|3|4
:TIME
Trigger setup
554
Table 12-1):
Setting
+2400.000 MHz
NORM
E9321A/25A: DEF
E9322A/26A: OFF
E9323A/27A: OFF
N1921/2A: OFF
Gate 1: 0.2 µs
Gates 2 - 4: 0
Gate 1: 366 µs
Gates 2 - 4: 0
N1911A/1912A P-Series Power Meters Programming Guide
Comments
Frequency setting
Measurement mode
Sensor video bandwidth
Delay between trigger point and time
gated period.
Length of time gated period for time gated
measurements.