Service:sensor[1]|2:Power:peak:maximum - Keysight N1911A Programming Manual

15 SERVice Subsystem

SERVice:SENSor[1]|2:POWer:PEAK:MAXimum?

This query returns the maximum peak power that can be measured by the
currently connected sensor. It is applicable to E-Series sensors only. Maximum
peak power information is stored in the sensor's EEPROM.
Syntax
SERV
Example
SERV:SENS2:POW:PEAK:MAX?
Error Messages
– If no sensor is connected, error –241, "Hardware missing" occurs.
– If a a sensor other than an E-Series sensor is connected, error –241 "Hardware
– If the E-Series sensor currently connected does not contain the necessary
716
:SENS
missing" occurs.
information in EEPROM, error –241 "Hardware missing" occurs.
N1911A/1912A P-Series Power Meters Programming Guide
:POW
1
2
This query returns the maximum peak power
that can be measured by the E-Series sensor
currently connected to Channel B.
:PEAK :MAX
?