Table 1-4 Model Of Sensor And Measurement Rates; Trigger Mode - Keysight N1911A Programming Manual

1 Power Meter Remote Operation
Sensor
Different measurement rates are achievable depending on the sensor type being
used, as shown in
Table 1-4 Model of Sensor and Measurement Rates
Sensor
8480 Series and N8480 Series
E-Series E4410 and E9300
E-Series E9320,
AVERage only mode
E-Series E9320,
NORMal mode
P-Series

Trigger Mode

The power meter has a very flexible triggering system. For simplicity, it can be
described as having three modes:
– Free Run: When a channel is in Free Run, it continuously takes measurements
– Triggered Free Run: When a channel is in Triggered Free Run Continuous
68
Table
Measurement Rate
NORMal
20 reading/s
50 ms
20 reading/s
50 ms
20 reading/s
50 ms
20 reading/s
50 ms
20 reading/s
on this channel. A channel is in free run when INITiate:CONTinuous is set to
ON and TRIGger:SOURce is set to IMMediate.
Trigger, it takes a new measurement each time a trigger event is detected.
A channel is in Triggered Free Run Continuous Trigger when
INITiate:CONTinuous is set to ON and TRIGger:SOURce is not set to
IMMediate.
N1911A/1912A P-Series Power Meters Programming Guide
1-4:
DOUBle
40 reading/s
25 ms
40 reading/s
25 ms
40 reading/s
25 ms
40 reading/s
25 ms
40 reading/s
FAST
NA
Up to 400
Up to 400
Up to 1000
Up to 1500