Unit[1]|2|3|4:Power <Amplitude_Unit - Keysight N1911A Programming Manual

UNIT[1]|2|3|4:POWer <amplitude_unit>
This command sets the power measurement units for a specified window/
measurement. The power suffix set by UNIT:POWer is used for any command
which accepts a numeric value in more than one unit
For the N1911A:
– UNIT1:POWer sets the power measurement units for the upper window/upper
– UNIT2:POWer sets the power measurement units for the lower window/upper
– UNIT3:POWer sets the power measurement units for the upper window/lower
– UNIT4:POWer sets the power measurement units for the lower window/lower
For ratio and relative power measurements:
– If UNIT:POWer is W, the measurement units are percentage.
– If UNIT:POWer is DBM, the measurement units are dB relative.
Syntax
Parameters
Item
amplitude_unit
N1911A/1912A P-Series Power Meters Programming Guide
measurement.
measurement.
measurement.
measurement.
UNIT 1
2
3
4
Description/Defaul t
The measurement unit.
– The default unit is dBm
Space
:POW
UNIT Subsystem
amplitude_unit
?
Range of Values
W
DBM
16
729