Keysight N1911A Programming Manual page 374

10 SENSe Subsystem
For most applications, automatic filter length selection
NOTE
([SENSe[1]]|SENSe2:AVERage:COUNt:AUTO ON) is the best mode of operation.
However, manual filter length selection ([SENSe[1]]|SENSe2:AVERage:COUNt
<numeric_value>) is useful in applications requiring either high resolution or
fast settling times, where signal variations rather than measurement noise need
filtering, or when approximate results are needed quickly.
Syntax
SENS
SENS2
Example
AVER:COUN:AUTO OFF
Reset Condition
On reset, automatic averaging is enabled.
Query
[SENSe[1]]|SENSe2:AVERage:COUNt:AUTO?
374
:
1 AVER
N1911A/1912A P-Series Power Meters Programming Guide
:COUN :AUTO
This command disables automatic filter
length selection for Channel A.
Space
0|OFF
1|ON
ONCE
?