System:communicate:lan:current:dname - Keysight N1911A Programming Manual

12 SYSTem Subsystem

SYSTem:COMMunicate:LAN:CURRent:DNAMe?

This command returns the current setting of the LAN domain name in use by the
power meter.
If DHCP or AutoIP are successfully enabled, then one of these IP address modes
NOTE
assign the LAN domain name, otherwise it is the static LAN domain name.
Syntax
SYST
Example
SYST:COMM:LAN:CURR:DNAM?
500
:COMM :LAN
N1911A/1912A P-Series Power Meters Programming Guide
:CURR :DNAM
This command queries the current setting of
the LAN domain name.
?