Keysight N1911A Programming Manual page 714

P-series power meters

Hide thumbs Also See for N1911A:

Table of Contents

SERVice Subsystem

Query Example

SERV:SENS:PCAL?

Error Messages

– If no power sensor is connected, error –241 "Hardware missing" occurs.

– If a a sensor other than an E9320 power sensor is connected, error –241

– If INIT:CONT is not set to OFF, error –221, "Settings conflict" occurs.

"Hardware missing" occurs.

N1911A/1912A P-Series Power Meters Programming Guide

This command returns the peak path

calibration factor block for Channel A.

Chapters

Table of Contents