System:communicate:lan:aip[:State] <Boolean - Keysight N1911A Programming Manual

SYSTem:COMMunicate:LAN:AIP[:STATe] <boolean>
This command enables the AutoIP protocol to dynamically assign the IP address
when connecting to the power meter in an isolated (non-site) LAN network (for
example, laptop to power meter).
Syntax
SYST
Example
SYST:COMM:LAN:AIP ON
Query
SYSTem:COMMunicate:LAN:AIP?
– 1 is returned if AutoIP is enabled
– 0 is returned if AutoIP is disabled
Query Example
SYST:COMM:LAN:AIP?
N1911A/1912A P-Series Power Meters Programming Guide
:COMM :LAN
:AIP :STAT
This command enables the AutoIP
This command queries the state of the
AutoIP.
SYSTem Subsystem
Space
0|OFF
1|ON
?
12
497