Keysight N1911A Programming Manual page 709

Query
SERVice:SENSor[1]|2:CORRections:STATe?
The query enters a 1 or 0 into the output buffer indicating the status of the voltage
to corrected power conversion.
– 1 is returned when voltage to corrected power conversion is enabled
– 0 is returned when voltage to corrected power conversion is disabled
Query Example
SERV:SENS:CORR:STAT?
Error Messages
– If INIT:CONT is not set to off, error –221, "Settings conflict" occurs.
– If the command is used when a sensor other than an E9320 power sensor is
N1911A/1912A P-Series Power Meters Programming Guide
connected, error –241, "Hardware missing" occurs.
This command queries whether voltage to
corrected power conversion is enabled for
Channel A.
SERVice Subsystem 15
709