Sense[1]]|Sense2:Correction:fdoffset|Gain4[:Input][:Magnitude - Keysight N1911A Programming Manual

10 SENSe Subsystem
Query Example
CORR:GAIN3:STAT?
Error Messages
– If [SENSe[1]]|SENSe2:CORRection:DCYCle:STATus is set to ON while
– If this command is used when an E4412A/E4413A power sensor is connected,
– If this command is used when a E9320 power sensor is set to NORMal mode,
– If this command is used when a P-Series power sensor is connected, the error
406
[SENSe[1]]|SENSe2:SPEed is set to 200, the error –221, "Settings Conflict"
occurs.
the error –310, "System error;Dty Cyc may impair accuracy with ECP sensor"
occurs. If you are using a dual channel power meter the error message
specifies the channel.
the error –221, "Settings Conflict" occurs.
–241, "Settings Conflict" occurs.
N1911A/1912A P-Series Power Meters Programming Guide
This command queries whether the pulse
measurement feature is on or off.