[Sense[1]]|Sense2:Average2 Commands - Keysight N1911A Programming Manual

P-series power meters

Hide thumbs Also See for N1911A:

Table of Contents

SENSe Subsystem

[SENSe[1]]|SENSe2:AVERage2 Commands

These commands control video averaging, which is used to improve measurement

accuracy, for the P-Series and E-Series E9320 power sensor. They combine

successive measurements to produce a new composite result.

If the command is used when a sensor other than a P-Series or E9320 power

sensor is connected, error –241, "Hardware missing" occurs.

If the commands in this section are used when an E9320 sensor is connected

and set to AVERage mode rather than NORMal mode, the error –221, "Settings

Conflict" occurs.

The following commands are detailed in this section:

[SENSe[1]]|SENSe2:AVERage2:COUNt <numeric_value>

[SENSe[1]]|SENSe2:AVERage2[:STATe] <boolean>

N1911A/1912A P-Series Power Meters Programming Guide

Table of Contents