9
PSTatistic Subsystem
PSTatistic[1]|2:CCDF:TRACe[:STATe] <boolean>
This command is used to turn on or off Channel A or Channel B trace.
This command is only applicable when P-Series sensors are present and the
NOTE
following conditions are met:
– Free-run acquisition mode is selected
– NORMal or DOUBle measurement speed setting is chosen
– Expanded window is enabled (not full CCDF screen window)
Syntax
PST
Example
PST:CCDF:TRAC ON
PST2:CCDF:TRAC OFF
Reset Condition
On reset, the trace of the physically connected channel will be shown.
356
1
:CCDF
2
N1911A/1912A P-Series Power Meters Programming Guide
:TRAC
:STAT
This command turns on Channel A trace.
This command turns off Channel B trace.
Space
0|OFF
1|ON
?