Calculate[1]|2|3|4:Limit:clear:auto <Boolean>|Once - Keysight N1911A Programming Manual

3 CALCulate Subsystem
CALCulate[1]|2|3|4:LIMit:CLEar:AUTo <boolean>|ONCE
This command controls when the FCO (fail counter) is cleared of any limit failures.
The FCO is used to determine the results returned by the
CALCulate[1]|2|3|4:LIMit:FAIL? query.
– If ON is specified, the FCO is set to 0 each time a measurement is:
– If OFF is specified, the FCO is not cleared by the above commands.
– If ONCE is specified, the FCO is cleared only after the first initialization then
Syntax
188
– Initiated using INITiate[:IMMediate]
– Initiated using INITiate:CONTinuous ON
– Measured using MEASure?
– Read using READ?
starts accumulating any limit failures.
CALC 1
2
3
4
N1911A/1912A P-Series Power Meters Programming Guide
:LIM :CLE
Space
:AUTO
?
0|OFF
1|ON
ONCE