Trace[1]|2:Measurement:transition[1] - Keysight N1911A Programming Manual

13 TRACe Subsystem
TRACe[1]|2:MEASurement:TRANsition[1]|...|10:NEGative:DURation?
This command returns the n
Syntax
TRAC
Reset Condition
On reset, this parameter is not affected.
Example
Error Messages
– If a P-Series sensor is not connected, error –241, "Hardware missing" occurs.
– If a P-Series sensor is connected and Free Run trigger acquisition is selected,
If you attempt to measure a pulse out of the range of the capture, for example,
NOTE
measure the 5th pulse and there are only 4 pulses displayed, the power meter
returns #0#0#0 as the result.
628
:MEAS
1
2
TRAC:MEAS:TRAN8:NEG:DUR?
error –221, "Settings conflict" occurs.
N1911A/1912A P-Series Power Meters Programming Guide
th
negative transition duration found on a trace.
:TRAN
1
2|...|10
This command returns the 8th negative
transition duration found on trace 1.
:NEG :DUR
?