Keysight N1911A Programming Manual page 763

Table A-3 Calibration Factor Block Layout: E9320 Series Sensors
E9320 Series Sensors:
Calibration Factor Block
Layout
Header:
Number of tables
Number of frequency
points
Bytes per frequency point 1
Frequency LSB weight
Header Total:
Cal Factor Table:
Frequency (point '0')
[b]
Cal factor
These table entries are repeated as shown for each frequency point
Frequency (point 'N')
Cal factor
Table Size:
N1911A/1912A P-Series Power Meters Programming Guide
No. Bytes Contents
1 1
2 -
-
2 1000
6
4 -
2 -
4 -
2 -
-
[c]
See note
Calibration Factor Block Layout
Data Format Data Range
- -
16 bit integer -
- -
-
32 bit fixed 0 to Fhpb*
(2^32)
2.14 0.25 to 3
32 bit fixed 0 to Fhpb*
(2^32)
2.14 0.25 to 3
Units Notes
None Number of cal factor
tables. This is currently
unused but has been set
to a default value of 1.
None
None Number of bytes in cal
factor value at each
frequency.
Hertz Fhbp (Freq. Hz per bit).
1 KHz per bit for the cal
factor: 1 KHz x 2^32 =
4.3E+12 = 4300 GHz
range
None Fhpb = Freq Hz per bit
None Used to adjust analog to
digital convertor (ADC)
values.
None Fhbp = Freq Hz per bit
None Used to adjust analog to
digital converter (ADC)
values.
The table size is
dependent on the number
of frequency points.
A
763