Measure[1]|2|3|4 Commands - Keysight N1911A Programming Manual

MEASure[1]|2|3|4 Commands

The MEASure? commands configure the power meter to perform a power
measurement with the given measurement function, relative mode setting, range
and resolution then makes the measurement. The format of the result is set by
FORM[:READ][:DATA]. Refer to
further information.
MEASure? is a compound command which is equivalent to:
– For the N1911A the MEASure? query is equivalent to:
– For the N1912A carrying out a single channel measurement the MEASure?
– For the N1912A carrying out a difference measurement the READ:DIFFerence?
– For the N1912A carrying out a ratio measurement the READ:RATio? queries
N1911A/1912A P-Series Power Meters Programming Guide
ABORt
CONFigure
READ?
queries are equivalent to:
ABORt1
CONFigure
READ1?
or
ABORt2
CONFigure
READ2?
queries are equivalent to:
ABORt1
ABORt2
CONFigure:DIFFerence
READ:DIFFerence?
are equivalent to:
ABORt1
ABORt2
CONFigure:RATio
READ:RATio?
MEASurement Commands
Chapter 6, "FORMat Subsystem,"
2
on page 261 for
161