Table 17-3 *Sre Mapping; Sre <Nrf - Keysight N1911A Programming Manual

*SRE <NRf>
The *SRE <NRf> command sets the Service Request Enable register bits. This
register contains a mask value for the bits to be enabled in the Status Byte
Register. A 1 in the Enable Register enables the corresponding bit in the Status
Byte Register; a 0 disables the bit. The parameter value, when rounded to an
integer and expressed in base 2, represents the bits 0 to 5 and bit 7 of the Service
Request Enable Register. Bit 6 is always 0.
register. Refer to the pullout at the end of Chapter 10 for further information.
Table 17-3 *SRE Mapping
Bit Weight
0 1
1 2
2 4
3 8
4 16
5 32
6 64
7 128
Syntax
N1911A/1912A P-Series Power Meters Programming Guide
Meaning
Not used
Not used
Device Dependent
QUEStionable Status Summary
Message Available
Event Status Bit
Not used
OPERation Status Summary
Space
*SRE
?
IEEE 488.2 Command Reference
Table 17-3
NRf
shows the contents of this
17
747