Keysight N1911A Programming Manual page 671

P-series power meters

Hide thumbs Also See for N1911A:

Table of Contents

TRIG:SEQ:SLOP NEG

Reset Condition

On reset the value is set to POSitive.

TRIGger[:SEQuence]:SLOPe?

The query returns the current value of <character_data>.

Query Example

TRIG:SEQ:SLOP?

Error Messages

– If 8480, N8480, E4410, E9300 or E9320 sensor is connected and trigger source

N1911A/1912A P-Series Power Meters Programming Guide

is not set to external, –221 "Settings conflict" occurs.

This command sets the trigger event to be

recognized on the falling edge of the

triggering signal.

This command queries the current value of

<character_data> for Channel A.

TRIGger Subsystem

Chapters

Table of Contents