Trigger[1]|2:Source Bus|External|Hold|Immediate|Internal[[1]|2] - Keysight N1911A Programming Manual

TRIGger[1]|2:SOURce
BUS|EXTernal|HOLD|IMMediate|INTernal[[1]|2]
This command configures the trigger system to respond to the specified source.
This command only selects the trigger source. Use the INITiate command to
place the power meter in the wait for trigger state.
– This command has been included for compatibility purposes. It has the same
NOTE
– If the source is set to INT, INT1 or INT2 when connecting the N1920 or E9320
Syntax
N1911A/1912A P-Series Power Meters Programming Guide
purpose as TRIGger[:SEQuence[1]|2]:SOURce
BUS|EXTernal|HOLD|IMMediate|INTernal[[1]|2] which should be used
in preference.
sensor in average mode, errors occurs.
TRIG
1
2
Space
:SOUR
TRIGger Subsystem
BUS
EXT
HOLD
IMM
INT
1
2
?
14
657