Keysight N1911A Programming Manual page 433

Reset Condition
On reset, autoranging is enabled.
Query
[SENSe[1]]|SENSe2:POWer:AC:RANGe:AUTO?
The query enters a 1 or 0 into the output buffer indicating the status of
autoranging.
– 1 is returned when autoranging is enabled
– 0 is returned when autoranging is disabled
Query Example
POW:AC:RANG:AUTO?
Error Messages
– If this command is set to OFF when there is not an E-Series power sensor or
– If this command is set to ON when E9320 power sensor is in Normal and
N1911A/1912A P-Series Power Meters Programming Guide
N8480 Series power sensor (excluding Option CFT) connected, the error –241,
"Hardware missing" occurs.
Triggered modes, the error -221, "Setting conflicts" occurs.
This command queries whether auto ranging
is on or off.
SENSe Subsystem 10
433