Usb Configuration - Keysight N1911A Programming Manual

P-series power meters

Hide thumbs Also See for N1911A:

Table of Contents

The character_data values for the IP address, Subnet Mask, and Default

Gateway can range between 0.0.0.0 and 255.255.255.255.

If you configure an invalid IP Address or an IP address that is used by another

device or host, an error message is generated. This error can be read by using

the SYSTem:ERRor? command.

The LAN setting values are stored in non-volatile memory and are not part of the

save-recall function.

USB Configuration

The USB interface requires no front panel or remote configuration.

The USB address cannot be changed - it is set at the factory and is unique for

each power meter.

For further information about the USB configuration refer to the P-Series Power

Meters Installation Guide.

Before connecting the USB cable, make sure that I/O software is installed on

your computer.

For more information about Keysight IO Libraries software refer to the

Connectivity Guide.

If you have installed other I/O Software, refer to documentation that

accompanies the software.

N1911A/1912A P-Series Power Meters Programming Guide

Power Meter Remote Operation

Table of Contents