Keysight N1911A Programming Manual page 404

10 SENSe Subsystem
Query
[SENSe[1]]|SENSe2:CORRection:DCYCle|GAIN3[:INPut]
[:MAGNitude]? [MIN|MAX]
The query returns the current setting of the duty cycle or the values associated
with MIN and MAX.
Query Example
CORR:GAIN3?
Error Messages
– If a duty cycle value is entered using
– If this command is used when an E4412A/E4413A power sensor is connected,
– If this command is used when a E9320 Series power sensor is set to NORMal
– If this command is used when a P-Series power sensor is connected, the error
404
[SENSe[1]]|SENSe2:CORRection:DCYCle|GAIN3 while
[SENSe[1]]|SENSe2:SPEed is set to 200, the error –221, "Settings Conflict"
occurs. However, the duty cycle value is set but the
[SENSe[1]]|SENSe2:CORRection:DCYCle|GAIN3:STATe command is not
automatically set ON.
the error –310, "System error;Dty Cyc may impair accuracy with ECP sensor"
occurs. If you are using a dual channel power meter the error message
specifies the channel.
mode, the error –221, "Settings Conflict" occurs.
–241, "Hardware missing" occurs.
N1911A/1912A P-Series Power Meters Programming Guide
This command queries the current setting of
the duty cycle for Channel A.