Keysight N1911A Programming Manual page 375

P-series power meters

Hide thumbs Also See for N1911A:

Table of Contents

The query enters a 1 or 0 into the output buffer indicating whether automatic filter

length is enabled or disabled.

– 1 is returned when automatic filter length is enabled

– 0 is returned when automatic filter length is disabled

Query Example

AVER:COUN:AUTO?

Error Messages

If [SENSe[1]]|SENSe2:AVERage:COUNt:AUTO is set to ON while

[SENSe[1]]|SENSe2:SPEed is set to 200, the error –221, "Settings Conflict"

occurs. However, automatic averaging is enabled but the

[SENSe[1]]|SENSe2:AVERage:STATe command is not automatically set ON.

N1911A/1912A P-Series Power Meters Programming Guide

This command queries whether automatic filter

length selection is on or off for Channel A.

SENSe Subsystem

Chapters

Table of Contents