Pstatistic:ccdf:gaussian:marker[1]|2[:Set] - Keysight N1911A Programming Manual

P-series power meters

Hide thumbs Also See for N1911A:

Table of Contents

PSTatistic:CCDF:GAUSsian:MARKer[1]|2[:SET]

This command is used to set the markers on Gaussian trace. The markers will be

set only if the trace is present and visible. According to the selections made, the

markers will become active on the screen.

This command is only applicable when P-Series sensors are present and the

following conditions are met:

– Free-run acquisition mode is selected

– NORMal or DOUBle measurement speed setting is chosen

– Expanded window is enabled (not full CCDF screen window)

PST:CCDF:GAUS:MARK

Reset Condition

On reset, the marker is set on the next visible trace according to the sequence

Channel A, Channel B, Reference or Gaussian.

N1911A/1912A P-Series Power Meters Programming Guide

This command sets marker 1 on the

Gaussian trace.

PSTatistic Subsystem

Table of Contents