Keysight N1911A Programming Manual page 297

Query Example
MEM:TABL:GAIN?
Error Messages
– If more than 81 calibration factors for sensor calibration tables, or 80 offsets
– If a table is not specified using the MEMory:TABLe:SELect command, the data
– If any of the calibration/offset factors are outside of the allowed range, error
N1911A/1912A P-Series Power Meters Programming Guide
for frequency dependent offset tables are in the list, error –108, "Parameter not
allowed" occurs.
cannot be entered and error –221, "Settings conflict" occurs.
–222, "Data out of range" occurs.
This command queries the calibration factor/
offset in the current table.
MEMory Subsystem 7
297