OUTPut:TRIGger[:STATe] <boolean>
This command enables or disables the trigger output signal.
When sensor is in triggered average measurement mode, the trigger output signal
will only be asserted after the measurement has settled.
This command is also applicable when used with 8480, N8480, E4410, E9300 or
NOTE
E9320 sensor (Average mode only).
Syntax
OUTP
Example
OUTP:TRIG:STAT 1
Reset Condition
On reset, the trigger output signal is disabled.
N1911A/1912A P-Series Power Meters Programming Guide
:TRIG
:STAT
Space
0|OFF
1|ON
?
This command enables the trigger output
signal.
OUTPut Subsystem
8
313