Summary Of Commands - Keysight N1911A Programming Manual

Summary of Commands

For detail of each SCPI (Standard Commands for Programmable Instruments)
command available to program the power meter, refer to later chapters for more
details on each command.
This Guide details the commands available for both the N1911A and the N1912A
NOTE
power meters. As the N1911A is a single channel power meter only Channel A
can be selected. Where instances of channel selection are detailed in this
document they are only relevant for the N1912A.
In different subsystems the numeric suffix of program mnemonics can represent
either a channel selection or a window selection. Refer to the appropriate
command description to verify the meaning of the numeric suffix.
With commands that require you to specify a channel, Channel A is represented
by a 1 and Channel B by a 2. If you omit the channel number, Channel A is
assumed.
With commands that require you to specify a window, the upper window is
represented by a 1 and the lower window by a 2. If you omit the window number,
the upper window is assumed.
All the commands listed also have queries unless otherwise stated in the "Notes"
column.
N1911A/1912A P-Series Power Meters Programming Guide
Power Meter Remote Operation 1
105