Output:recorder[1]|2:Feed <Data_Handle - Keysight N1911A Programming Manual

OUTPut:RECorder[1]|2:FEED <data_handle>
This command specifies which measurement is sent to the recorder output
specified by the numeric value following RECorder. RECorder1 applies to both
single and dual channel power meters. RECorder2 applies to dual channel power
meters only.
Syntax
OUTP
Parameters
Item
data_handle
Example
OUTP:REC2:FEED "CALC1"
Reset Condition
On reset, data_handle is set to its previous value.
N1911A/1912A P-Series Power Meters Programming Guide
:REC
Description/Defaul t
The CALC block specifying the measurement to be sent to
the recorder output.
:FEED
1
2
This command sends the CALC1
measurement to recorder output 2.
OUTPut Subsystem
Space data_handle
?
Range of Values
"CALC1" or "CALC"
"CALC2"
"CALC3"
"CALC4"
8
305