[Sense[1]]|Sense2:Average:count <Numeric_Value - Keysight N1911A Programming Manual

P-series power meters

Hide thumbs Also See for N1911A:

Table of Contents

SENSe Subsystem

[SENSe[1]]|SENSe2:AVERage:COUNt <numeric_value>

This command is used to enter a value for the filter length. If

[SENSe[1]]|SENSe2:AVERage:COUNt:AUTO is set to ON then entering a value for

the filter length automatically sets it to OFF. Increasing the value of filter length

increases measurement accuracy but also increases the time taken to make a

power measurement.

Entering a value using this command automatically turns the

[SENSe[1]]|SENSe2:AVERage:STATe command to ON.

For most applications, automatic filter length selection

([SENSe[1]]|SENSe2:AVERage:COUNt:AUTO ON) is the best mode of operation.

However, manual filter length selection ([SENSe[1]]|SENSe2:AVERage:COUNt

<numeric_value>) is useful in applications requiring either high resolution or fast

settling times, where signal variations rather than measurement noise need

filtering, or when approximate results are needed quickly.

N1911A/1912A P-Series Power Meters Programming Guide

Chapters

Table of Contents