Keysight N1911A Programming Manual page 451

Reset Condition
On reset, the delay is set to 0 seconds.
Query
SENSe[1]|SENSe2:TRACe:OFFSet:TIME?
The query returns the current delay between the delayed trigger point and the
start of the trace.
Query Example
SENS:TRAC:OFFS:TIME?
Error Messages
– If the command is used when a sensor other than a P-Series or E9320 power
– If the command is used when an E9320 sensor is connected and set to
N1911A/1912A P-Series Power Meters Programming Guide
sensor is connected, error –241, "Hardware missing" occurs
AVERage mode rather than NORMal mode, the error –221, "Settings Conflict"
occurs.
This command queries the current delay
between the delayed trigger point and the
start of the trace for Channel A.
SENSe Subsystem 10
451