Pstatistic[1]|2:Ccdf:trace:marker[1]|2[:Set] - Keysight N1911A Programming Manual

9 PSTatistic Subsystem

PSTatistic[1]|2:CCDF:TRACe:MARKer[1]|2[:SET]

This command is used to set the marker on Channel A or Channel B trace. The
markers will be set only if the trace is present and visible. According to the
selections made, the markers will become active on the screen.
This command is only applicable when P-Series sensors are present and the
NOTE
following conditions are met:
– Free-run acquisition mode is selected
– NORMal or DOUBle measurement speed setting is chosen
– Expanded window is enabled (not full CCDF screen window)
Syntax
Example
PST:CCDF:TRAC:MARK
PST2:CCDF:TRAC:MARK2
Reset Condition
On reset, the marker will be set on the next visible trace according to the
sequence Channel A, Channel B, Reference or Gaussian.
358
1
PST :CCDF
2
:TRAC
This command sets the marker1 on Channel A.
This command sets the marker2 on Channel B.
N1911A/1912A P-Series Power Meters Programming Guide
1
:MARK
2
:SET