Memory Subsystem - Keysight N1911A Programming Manual

P-series power meters

Hide thumbs Also See for N1911A:

Table of Contents

MEMory Subsystem

The MEMory command subsystem is used to:

– Edit and review sensor calibration tables (8480 Series sensors and N8480

– Store sensor calibration tables (8480 Series sensors and N8480 Series sensors

– Edit and review sensor frequency dependent offset tables

– Store sensor frequency dependent offset tables

– Edit and review sensor save/recall registers

Stored tables remain in the power meter's memory during power down. The

power meter is capable of storing 20 sensor calibration tables and 10 frequency

dependent offset tables of 80 frequency points each.

The MEMory subsystem is not used for E-Series, N8480 Series (excluding Option

CFT) and P-Series power sensors calibration tables. These are automatically

downloaded to the power meter and cannot be reviewed or edited.

Series sensors with Option CFT only)

with Option CFT only)

N1911A/1912A P-Series Power Meters Programming Guide

Parameter Form

<character_data>

[query only]

[query only]

[query only]

[query only]

Table of Contents