[Sense[1]]|Sense2:Correction:dcycle|Gain3 Commands - Keysight N1911A Programming Manual

[SENSe[1]]|SENSe2:CORRection:DCYCle|GAIN3 Commands

These commands control the pulse power measurement feature of the power
meter.
The following commands are detailed in this section:
[SENSe[1]]|SENSe2:CORRection:DCYCle|GAIN3[:INPut]
[:MAGNitude] <numeric_value>
[SENSe[1]]|SENSe2:CORRection:DCYCle|GAIN3:STATe <boolean>
You can use either DCYCLe or GAIN3 in these commands, both do the same.
NOTE
Using GAIN3 complies with the SCPI standard whereas DCYCle does not, but may
make your program more understandable.
N1911A/1912A P-Series Power Meters Programming Guide
SENSe Subsystem 10
401