Calibration[1]|2:Rcalibration <Boolean - Keysight N1911A Programming Manual

CALibration[1]|2:RCALibration <boolean>
This command enables and disables the zero/cal lockout facility. With the lockout
facility enabled the power meter is stopped from making measurements until the
connected sensor has been zeroed and calibrated.
Syntax
Example
CAL1:RCAL 1
Reset Condition
On reset, the state of the zero/cal lockout is unaffected.
Query
CALibration[1]|2:RCALibration?
The query enters a 1 or 0 into the output buffer indicating whether zero/cal
lockout is enabled or disabled.
– 1 is returned if zero/cal lockout is enabled
– 0 is returned if zero/cal lockout is disabled
N1911A/1912A P-Series Power Meters Programming Guide
CAL
1
2
Space
:RCAL
?
This command enables the zero/cal lockout
facility on Channel A.
CALibration Subsystem
0|OFF
1|ON
4
221