2
MEASurement Commands
MEASure[1]|2|3|4[:SCALar][:POWer:AC]:RELative?
[<expected_value>[,<resolution>[,<source list>]]]
This command sets the specified window's measurement function to single
channel with relative mode on, aborts, configures then initiates the specified
channel, calculates the measurement result and places the result on the bus. The
result is a ratio based measurement and is expressed in the units defined by
UNIT[1]|2|3|4:POWer:RATio. The relative value used is that set by the
CALCulate:RELative:MAGNitude:AUTO command.
Syntax
MEAS
1
2
3
4
Parameters
Refer to
parameters in this command.
Item
expected_value
(for the expected power
level)
resolution
164
:SCAL
:POW
expected_value
Space
DEF
"Optional Parameters"
Description/Defaul t
A numeric value for the expected power level. The units of
measurement are dBm and W. The default units are defined by
UNIT:POWer.
A numeric value for the resolution. If unspecified the current
resolution setting is used.
N1911A/1912A P-Series Power Meters Programming Guide
:AC
:REL
,
resolution
DEF
on page 112 for additional details on the
?
,
source list
Range of Values
sensor dependent
[a]
DEF
[b]
1 to 4
1.0, 0.1, 0.01, 0.001
[a]
DEF