Measure[1]|2|3|4[:Scalar][:Power:ac]? [<Expected_Value>[,<Resolution>[,<Source List>]]] - Keysight N1911A Programming Manual

2 MEASurement Commands
MEASure[1]|2|3|4[:SCALar][:POWer:AC]?
[<expected_value>[,<resolution>[,<source list>]]]
This command sets the specified window's measurement function to single channel
with relative mode off, aborts, configures the window then initiates Channel A or B,
calculates the measurement result and places the result on the bus.
Syntax
MEAS
1
2
3
4
Parameters
Refer to
parameters in this command.
Item
expected_value
(for the expected power level)
resolution
source list
162
:SCAL :POW
expected_value
Space
DEF
"Optional Parameters"
Description/Defaul t
A numeric value for the expected power level. The units of
measurement are dBm and W. The default units are defined
by UNIT:POWer.
A numeric value for the resolution. If unspecified the current
resolution setting is used.
The channel which the command is implemented on.
If unspecified the current window setup is used. However, on
the N1912A, if the window shows a ratio or difference
measurement, the upper window defaults to Channel A and
the lower window to Channel B.
N1911A/1912A P-Series Power Meters Programming Guide
:AC ?
,
resolution
DEF
on page 112 for additional details on the
,
source list
Range of Values
sensor dependent
[a]
DEF
[b]
1 to 4
1.0, 0.1, 0.01, 0.001
[a]
DEF
(@1)
(@2) (N1912A only)