Keysight N1911A Programming Manual page 293

Example
MEM:TABL:FREQ 200kHz,600kHz
Query
MEMory:TABLe:FREQuency?
The query returns a list of frequency points for the table currently selected. The
frequencies are returned in Hz.
Query Example
MEM:TABL:FREQ?
Error Messages
– If more than 80 frequencies are in the list, error –108, "Parameter not allowed"
– If the frequencies are not entered in ascending order, error –220, "Parameter
– If a table has not been specified using the MEMory:TABLe:SELect command,
– If a frequency is sent which is outside of the allowed frequency range, error
N1911A/1912A P-Series Power Meters Programming Guide
occurs.
error;Frequency list must be in ascending order" occurs.
the data cannot be entered into the table and error –221, "Settings conflict"
occurs.
–222, "Data out of range" occurs.
This command enters frequencies of 200 kHz
and 600 kHz into the currently selected
table.
This command queries the frequency points
in the currently selected table.
MEMory Subsystem 7
293