Figure 1-2 Typical Averaged Readings On 8480 Series Sensors; Auto Averaging Mode - Keysight N1911A Programming Manual

1 Power Meter Remote Operation

Auto Averaging Mode

To enable and disable auto filter mode, use the following command:
[SENSe[1]]|SENSe2:AVERage:COUNt:AUTO <boolean>
When the auto filter mode is enabled, the power meter automatically sets the
number of readings averaged together to satisfy the filtering requirements for
most power measurements. The number of readings averaged together depends
on the resolution and the power level currently being measured.
the number of readings averaged for each range and resolution when the power
meter is in auto filter mode.
Figure 1-2
NOTE
Figure 1-2
Figure 1-3
58
applies to 8480 Series only.
Minimum Sensor Power
10 dB
10 dB
10 dB
10 dB
Maximum Sensor Power
Typical Averaged Readings on 8480 Series Sensors
illustrates part of the power sensor dynamic range hysteresis.
N1911A/1912A P-Series Power Meters Programming Guide
Figure 1-2
Resolution Setting
1 2 3
8 8 128
1 1 16
1 1 2
1 1 1
1 1 1
lists
4
128
256
32
16
8