Keysight N1911A Programming Manual page 426

10 SENSe Subsystem
Example
FREQ:STOP 1MHz
Query
[SENSe[1]]|SENSe2:FREQuency[:CW|:FIXed]:STOP?
This query is used to retrieve stop frequency of the average or peak frequency
sweep. Frequency returned is in Hz.
Query Example
FREQ:STOP?
On Reset
On *RST, the value is set to 50 MHz.
Error Messages
– If no sensor or wrong sensor is connected to the channel, error –241,
– If parameter set is lower than 1 kHz, error –222, "Data out of range; value
– If parameter set is higher than 1000 GHz, error –222, "Data out of range; value
426
"Hardware missing" occurs.
clipped to lower limit" occurs.
clipped to upper limit" occurs.
N1911A/1912A P-Series Power Meters Programming Guide
This command sets frequency sweep to stop
at 1 MHz for Channel A.
This query returns the stop frequency of
frequency sweep in Hz for Channel A.