2
MEASurement Commands
Example
READ1:REL? DEF,1,(@2)
Error Messages
– INITiate:CONTinuous must be set to OFF, otherwise error –213,
– If TRIGger:SOURce is set to BUS or HOLD, error –214, "Trigger deadlock" occurs.
– If the expected value and resolution parameters are not the same as the
150
"INIT ignored" occurs.
current expected value and resolution settings on the specified window,
error –221, "Settings conflict" occurs.
N1911A/1912A P-Series Power Meters Programming Guide
This command queries the upper window/
upper measurement relative measurement
of Channel B, using the current sensor
range and a resolution of 1.